Bench Racing

If you are unable to see the message below, click here to view.

Send to a Friend | Sign Up for Bench Racing e-newsletter

April 20, 2010
One Sweet Wheel and Tire Mockup Tool

You're pretty good at eyeballing it. You can say things like, "that looks like a 7/16" or "the camber and toe look pretty close" and actually be right, but add a few more simultaneous calculations into the mix and you've got a challenge.

A good example is guessing the clearance of a wheel and tire's profile, width and backspacing when fractions of an inch are at stake. Guessing wrong means that rolling investment doesn't look right or worse yet, it's all going back to the store.

Percy's High Performance has a clever tool that gets very precise with all these calculations and physically shows you the limits of clearance. It works with four or five lug patterns, wheels up to 11 ¾; inches wide and tires up to 30 inches.

Check out Percy's WheelRite fitment tool.

Pressure Player
Inflate to Explode

Dog Gone
Good Tires

SHARE THIS BENCH RACING

PAST E-NEWSLETTERS

		April 13, 2010 Custom Car Titling Strategies Read Full Article
		April 6, 2010 Straight Six Runs 216 mph! Read Full Article

SEND TO A FRIEND | CONTACT US | ADVERTISE
EDITORIAL POLICY | PRIVACY POLICY | UNSUBSCRIBE
MANAGE YOUR PREFERENCES
© 2010 National Street Machine Club

Be sure to add club_news@streetmachineclub.messages3.com to your address book or safe sender list so our email gets to your inbox. Please do not reply to this message as the "reply to" function does not allow us to receive your email.

National Street Machine Club | 12301 Whitewater Drive | Minnetonka, MN 55343